Uniden UBC60XLT Manual de usuario

UBC60XLTProgrammabieHand-HeldScannerOPERATING GUIDE

Programming Channels1. Select frequency.2. Select channel using Manual mode.Note: For channel 10, press (T),

— OR—Press© 0repeatedly to step — through—®channels(Mj ...; ^ sCEIC0 c o G o o o c3, Enter frequency.3a. If frequency outside range.Each digit dis

4. Recheck frequency.The frequency appears one digit at a time in sequence.Repeal these steps to program each channei.You can program the same frequen

How Squelch Worksstrong Signals-Modijm Signals Weak Signals Noise----------Think of “SQUELCH" as a gate.If the gate is set too low (SQUELCH too l

Setting the Squelch1. Turn until hiss heard.This action lowers the “squelch gate,” allowing all signals and noise to get through.No signal should be p

To hold on that channel:The scanner skips any unprogrammed channels, and locked out channels.Scanner stops on that channel.When the transmission ends,

To resume scanning:Scanner immediately resumes scanning.To listen to or program a specific channel:Note: Forchannel 10, press (J),(J).Press @1 to re

Channel LockoutChannel Lockout lets you skip channels during scanning. There are two ways to lock out a channel:Manual ModePress channel numberThen_

When the scanner stops on a channe! during scanning, you can lock out that channel by pressing ( DO ].Because the locked out channel Is no longer scan

Note: Forchannel 10, press (T), (o).The UO indicator disappears from the display after pressingScanning Weather Channels(Weather Channels are not used

PRECAUTIONSBefore you use this scanner, please read and observe the following; WARNING!Uniden DOES NOT represent this unit to be waterproof.To reduc

To review the weather frequency:The UBC60XLT finds the active weather channel in your area from seven preprogrammed frequencies.Note: The channel numb

Care and MaintenanceLow Battery WarningWhen the Batteries become weak, you will hear an audible warning. Be sure to replace Alkaline Batteries as soon

Optional Accessories and Replacement PartsThe following optional accessories and replacement parts for your UBC60XLT are available from your local Uni

Operating TipsIf your UBC80XLT is not perfoming properly, try the steps listed below.CONDITION SUGGESTIONScanner doesn’t turn on.Rotate the Volume con

CONDITIONSUGGESTIONScan doesn't stop.Adjust the Squelch setting. It may be too high.Check the antenna connection. Make sure the antenna is in a v

Technical SpecificationsChannels:WX:FrequencyCoverage:Scan Rate: Scan Delay: Audio Output: Antenna:OperatingTemperature:Size:Weight:PowerRequirements:

WarrantyUniden UBC60XLT Scanning Receiver Australian 1 Year WarrantyNote: Please keep your sales docket as it provides evidence of warranty.WARRANTOR;

Controls.a tn•s tU1. LCD Display 7.2. Scan Key 8.3. Manual Key 9.4. Lockout Key10.5. Weather Scan Key 11.6.Keylock Key12.13. Antenna Connector14. Phon

uniden©1994 Uniden Australia Pty. Umited. All rights reserved. UBZZ01240AZ Printed in the Phillippfnes

Table of ContentsAbout Your New UBC60XLT...2Feature Highlights...

About Your New UBC60XLTThe UBC60XLT is a brand new state-of-the-art information radio with automatic scanning capabilities. It can store frequencies s

Types of CommunicationYou will be able to monitor communication such as: Police and fire department {including rescue and paramedics) Business/ind

Included with the UBC60XLT

SetupPowerInstalling Batteries1. Open cover.3. Replace cover.IMPORTANTIf you are installing Alkaline Batteries, set the switeh to “Reg. Aik ВАТТ.&quo

AC Adaptor/ChargerUse the optional AC Adaptor/Charger to power the UBC60XLT from an AC source.The AC Adaptor/Charger also recharges Nickel-Cadmium Bat

OperationKeylockKeylock prevents accidental key entries. To lock:^...^rmji.'T .it m ? * ; si""o G o c; G O G Q COnly the Clw