Uniden GC45W Manual de usuario Pagina 1

GC45 AND GC45W ACCESSORY CAMERA USER’S MANUALWHAT’S IN THE BOXGC45 or GC45W video cameraCamera stand AC adapterFour Wall Anchors and screws (Not Shown

10TROUBLESHOOTING CAMERA PAIRINGConsult the following table for camera pairing troubleshooting suggestions:If... Try... the camera’s signal status ic

11PRODUCT SPECIFICATIONSThe following specifications apply to both the GC45 and GC45W cameras.Radio Frequency TransceiverRF Frequency 2.4 GHzModulatio

12Camera SpecificationsPicture sensor OV7725 1/4’ Color CMOSLens F3.6mm H:53 V:40

13ADDITIONAL INFORMATIONRecycling and Disposal Information • Do not dispose of electronic devices or any of their components (especially batteries and

14 • Plug the equipment into an outlet on a circuit dierent from that to which the receiver is connected. • Consult the dealer or an experienced radi

15One-year Limited WarrantyImportant: Evidence of original purchase is required for warranty service.WARRANTOR: Uniden America Corporation (“Uniden”)

16LEGAL REMEDIES: This warranty gives you specic legal rights, & you may also have other rights which vary from state to state. This warranty is

17

18

Important Safety Instructions!This manual contains important information about this product’s operation. If you are installing this product for others

• WARNING: KEEP OUT OF THE REACH OF CHILDREN. This product is not a toy and is not intended for use by any children under the age of 13. If you are b

4CONTENTSImportant Safety Instructions! ...2Warnings to Parents and Other Users ... 2For best results: ...

5GETTING TO KNOW THE CAMERACAMERA COMPONENTS AND INDICATORSFront view Back viewPower statusLink statusLight sensorAntenna connectorPower pigtailPower/

6MOUNT THE CAMERA STANDGENERAL GUIDELINESThe Uniden Guardian GC45 and GC45W cameras are weatherproof and have an IP66 rating. Water can be sprayed on

7 • Rainfall, pool water ripples/reflections, tree/shrub leaves blowing in the wind - and the shadows they create - can generate motion detection fals

86. Connect one end of an AC adapter to the camera’s power pigtail and plug the other end into a 120 volt AC (standard indoor) power outlet (if neces

9PAIRING CAMERASYour receiver supports a total of four active cameras at a time. When you add a camera, you have to pair it to the receiver (that is,