Uniden EXT1865 El manual del propietario

1EXT1865 7/25/00 16:31 Page 1

7Standard wall plate mountingThis phone can be mounted on any standard telephone wall plate.1 Snap the wall mountadapter into thenotches on the base.2

8Direct wall plate mountingIf you don't have a standard wall plate, you can mount your phonedirectly to the wall. Before doing this, consider the

9Charge the battery pack for more than 17 hours before you startusing your phone.1 Press in on the battery coverrelease and slide the coverdown until

10Battery use time (per charge)From fully charged• Seven hours continuous use• Ten days when the handset is in the standby modeWhen the battery charge

113 The number is dialed. Afterabout 5 seconds, the call-timedisplay appears.4 To hang up, press orplace the handset on the base.The call-time will b

With the base1 Press .2 Dial the number on thekeypad.3 When you finish the call,press to hang up.12Dialing from talk mode1 Press . “Talk” flashes on

131 Phone rings.2 Press . “Talk” and volumesetting appear on the display.3 Talk with the caller.4 To hang up, press or place thehandset on the base.

141 The base rings. The statuslamp on the base flashes.2 Press .3 When you finish the call,press to hang up.With the baseEXT1865 7/25/00 16:31 Pag

Handset ringer volumeIn the standby mode, press or on the handset to select oneof four ringer tone and volume combinations. Handset ringer on/off sw

16The last three phone numbers dialed can be quickly redialed.Redialing from standby1 Press .The phone number that was last dialedappears on the displ

Controls and functionsEXT1865 7/25/00 16:45 Page 3

17Redialing from the talk mode1 Press . “Talk” flashes and the volume settingappears.2 Press .The last number dialed from the handsetwill be displayed

1 Press and hold until “Memory Store” is displayed.2 Use and or enter a two-digitnumber (01 - 20) to select the memorylocation where you would like

195 Press .“Store Number” isdisplayed. The cursor flashesindicating that the display isready for the number to be entered.6 Use the number keypad orto

20You can only store numbers in the base’s memory.1 Press .The status LED blinks.2 Dial the number you wantto store (up to 20 digits).3 Press andenter

21To exit the memoryfunction without dialing,press . Thehandset returns to standby.If you press before you canconfirm the name andnumber stored in the

22Memory dialing from talk mode1 Press .“Talk” flashes and the volume settingappears.2 Press .3 Enter a two-digit number (01 - 20) toselect the memory

4 Press the or to select“Edit Memory”,then press .The following screen appears.The cursor flashes indicating that the display is ready for thename to

247 Use the dial keypad, or to edit thephone number. The phone number cannot exceed 20 digits.When the phone number will not be edited, skip this st

254 Press to move the cursordown to “Delete Memory”command line.5 Press . The followingconfirmation screen appears.6 Press to move the cursor to “Y

261 Press .The status LED blinks.2 Press again.3 Enter the memory locationnumber (0-9) you want todelete. A confirmation tonesounds and the number ise

Congratulations on your purchase of the EXT 1865 cordlesstelephone. This phone is designed for reliability, long life, andoutstanding performance.Note

27The Uniden EXT 1865 permits 3-way conversations between thehandset, base and an outside line.3-way conference features3-way conference1 Press on th

28Intercom featureUsing your EXT 1865 intercomPaging from the base to handset1 Press and releaseon the base.The handset beeps. (If noanswer, pressagai

291 Press on thebase. The caller is put onhold and the intercom tonesounds on the handset.2 Press or on the handset. Theintercom mode is activatedbut

30You can access a list of calling services provided by your localtelephone company by pressing the key on the handset orthree menu keys ( , and )

31CALLER IDFEATURESYou must subscribe to the Caller ID service to use this feature.When the telephone rings, the Caller ID feature allows you to viewt

321 When the Caller ID message is received, the display shows thecaller’s phone number along with the date and time. Theincoming call information is s

33“End” appears whenyou have reviewed allmessages in the Caller IDlist. Press repeatedlyto return to the summaryscreen.If a call comes in via ateleph

34The EXT 1865 stores up to 50 messages. When the phone receivesthe 51st message, the oldest one in the list is automatically deleted.Caller ID data c

35Deleting all Caller ID name/numbers1 Press .2 Press .3 Press or to select “Yes” or“No”.4 Press or .When the pointer is at “Yes”:A tone sounds and a

36Calling a party from the Caller ID listYou can place a call from the Caller ID list.The EXT 1865 stores up to 50 messages.1 Press .Select the phone

Introduction / Features ...inside front coverControls and Functions...inside front coverGetting StartedRead this first...

37Storing Caller ID messages in Memory dialingMessages shown in the Caller ID list can be stored in memorydialing.Using the incoming call information

38“Caller ID” and “Call Waiting” are separate services. CIDCW(Caller ID on Call Waiting) performs the same as regular CallerID on a call waiting numbe

39If the handset battery packis completely dischargedor the battery pack isremoved, the digitalsecurity code will be lost.If this happens, a newsecuri

40To attach the beltclipInsert the beltclip into the holeson each side of the handset.Press down until it clicks.To remove the beltclipPull both sides

Caution•Use the specified battery pack.•Do not remove the battery from the handset to charge it.•Never throw the battery into a fire, disassemble it,

SymptomThe status LED won'tcome on when thehandset is placed inthe base unit.The audio soundsweak and/or scratchy.Can't make or receivecalls

43At Uniden, we’ll take care of you!If you need any assistance with this product, please call our Customer Hotline at1-800-297-1023PLEASE DO NOT RETUR

44INDEX0-93-way Conference ...27AAdjusting ringer and earpiece/speaker volume...15Advanced Calling Features..30BBattery packPreparing a

EXT1865 7/25/00 16:34 Page 45

2This cordless telephone must be set up before use. Follow these steps;Step 1 (page 3)Unpack and check the telephone and accessories.Step 2 (page 4 to

Uniden Parts Department(800) 554-3988Hours: M-F 7:00 AM to 5:00 PM CST.We can also be reached on the web at www.uniden.com.3Make sure you have receive

4Do the following steps.• Choose the best location• Connect the base unit• Choose the dialing modeChoose the best locationBefore choosing a location f

5Connect the base unitIf you want to install the base unit on the wall, see page 7.Place the power cord so itdoes not create a triphazard, or where it

6Use only the supplied AD-420 ACadapter. Do not use any other ACadapter.Connect the AC adapter to acontinuous power supply.Place the base unit close t