Uniden BCD396T Manual de usuario descargar pdf (Pagina 2)

Backing Up Your Scanner

While it doesn’t happen often, it is possible that applying a firmware update could affect some of your

scanner’s programmed settings or systems. We recommend you make a full backup of your scanner’s

programming and configuration before you apply the update. Follow these quick steps to make a backup

of your BCD996T programming using Uniden Advanced Scanner Director (UASD):

1. Install (if necessary) and run UASD.

2. From the main menu, select “Scanner View.”

3. From the top menus, select Setup Æ Options.

4. Set the COM port to the port you’ve connected the BCD996T to and select the baud rate that

matches your scanners SettingsÆSet Serial PortÆSet Baud RateÆFront Port setting and then

click OK.

5. Select Read from Scanner from the top function bar.

The software will begin to read the contents of your scanner.

6. When UASD finishes reading from the scanner, select Save to Data Base from the top function

bar.

7. Make sure the check boxes next to Save Configuration, Save Location Alert Systems, Save

Selected Systems, and Replace existing files with same names are checked, then enter a name

for your configuration in the text box next to Save Configuration as:, the click OK.

Applying the Update

Before applying the update, you need to download two files from the Uniden America Corp. web site.

Logon to http://www.uniden.com/my and register your scanner. On your “My Scanners” page, click on

the link for BCD996T downloads. The following files are required for this update:

• BCD996T_V1_04_12.zip – this is the compressed scanner firmware file

• BC_VUP_v2.0.0.2.exe – this is the application that applies the new firmware to your scanner. If

you have already installed this version, you do not need to d/l and install again. Installing this

version automatically replaces any previous version.

1. Navigate to the location where you saved the above files and unzip the first file (it will be

BCD996T_V1_04_12.scn).

2. If you have not previously installed the BC_VUP firmware updater, run the

“Install_BC_VUP_v2.0.0.2.exe” program. This installs the firmware version updater on your PC.

(Note: If you have previously installed this version, you do not need to install it again.)

3. Run the installed application in the “Guided mode.” When prompted, select the scanner firmware

file you downloaded.

1 2 3 4 5 6

Sin comentarios

Uniden BCD396T Manual de usuario Pagina 2