Uniden UWG700 El manual del propietario descargar pdf (Pagina 9)

With the wires pulled through the hole on the backing and 11.

mounts, and the devices paired, screw the small backing back

onto the back of the camera.

• If connecting a door strike, please see connecting an electric

door strike before placing the backing back on camera.

Note: The devices will only pair when the camera is plugged into a

power source

Battery Powering the Camera (Optional)

Note: Using the AC adaptor is the recommended method of powering

the camera. The camera can operate in a limited capacity using

batteries; for typical operation lasting 1 minute, 5 times per day, the

system can last up to 3 months.

Remove the entire backing from the back of the camera by removing 1.

the screws along the edges.

Insert 6 AA batteries into the provided battery slots.2.

Ensure that the camera and monitor are paired with one another. 3.

(see Pairing on p.19.)

(Optional) Disconnect (if previously connected) the black and red 4.

wires from the negative and positive slots.

Screw the backing, back onto the camera. 5.

Note: Batteries are not included.

With wires pulled through rubber

plug, screw backing on

Insert 6 AA batteries in

provided space

UWG700 OM.indd 9 28/9/11 9:41:39 AM

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Sin comentarios

Uniden UWG700 El manual del propietario Pagina 9