Uniden DECT1825 El manual del propietario Pagina 14

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 48
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 13
Handsfree mode
End a call
Receive a call
Call Waiting
Australia:
New Zealand:
Receiving internal calls
You can use handsfree mode to talk to your caller
without holding the handset to your ear. You can
speak into the handset microphone and listen over
the loudspeaker.
Handsfree also enables other people in the room to
listen in to the conversation.
1 Press . The symbol is displayed while
in handsfree mode.
2 Press again to go back to the normal talk
mode.
1 Press .
Place the handset back on the base/charger.
The call time will remain in the display for a
further 5 seconds.
When you receive a call the handset(s) will
ring (as long as handset ring volume is not set to
OFF - see page 20).
The symbol will flash in the handset display.
If you have subscribed to a Caller ID service
through your network supplier, the caller’s number
will be displayed (if available). See page 32 for
further information on Caller Id
You can also turn the ringer off temporarily, by
pressing and holding while the phone rings.
1 Press to answer the call.
Or simply lift the handset from the base (providing
Auto Talk is set to On, see page 21).After a short
delay the call timer will start timing the call.
If you subscribe to Call Waiting and the call waiting
tone sounds during a call:
Press then 2 to switch between
callers.
Press to switch between
callers.
If you receive a call from another handset, the
internal caller’s handset number will be displayed.
During a call:
Or
.
end
talk
[13]
cid/
flash
cid/
flash
clear
Vista de pagina 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Comentarios a estos manuales

Sin comentarios